Configuring for the Ricoh ProcessDirector Transform features

If you have installed one or more of the Ricoh ProcessDirector Transform features, you can configure Ricoh ProcessDirector to use these features.
The AFP Support feature must be installed before you can perform this procedure.

This procedure is for use with the Ricoh ProcessDirector Transform features, such as PostScript/PDF to AFP, Ricoh SAP to AFP, and Ricoh PCL to AFP, not the Advanced Transform feature.

After you have identified the Transform features to Ricoh ProcessDirector, you can define an input device that receives jobs to be transformed and a workflow that sends jobs to be converted. To see which Transform features are installed, open the Transform feature user interface and check the About page.

To configure to work with the Ricoh ProcessDirector Transform features:

  1. Click the Administration tab.
  2. In the left pane, click System → Settings.
  3. In the left pane, click Settings → System.
  4. Make sure that the Transform server IP address or host name property is the IP address or host name of the primary computer.
    If the primary computer has two network cards, it has two IP addresses, but Ricoh ProcessDirector uses only one. Make sure that the property is set to the correct IP address.
  5. Make sure that the Transform server port number property matches the port number that is configured for the data transform program.
  6. Click OK.
  7. Click SAVE.
  8. Edit the TransformJobIntoAFP or TransformJobIntoPDF step template to set job property defaults.
 
Copyright © 2006, 2018