Valid Form Lengths in Inches

Table 31. Examples of some valid form lengths in inches
If the Form Length is: Use this value at the Touch Panel Use this value at the Stacker Control Panel:
3.0 3.0 See note 2
31/2 3.5 See note 2
4.0 4.0 See note 2
41/2 4.5 See note 2
5.0 5.0 See note 2
51/2 5.5 See note 2
6.0 6.0 See note 2
61/2 6.5 See note 2
7.0 7.0 7.0
71/2 7.5 71/2
8.0 8.0 8.0
81/6 8.1 See note 1
81/3 8.3 81/3
81/2 8.5 8
82/3 8.6 82/3
85/6 8.8 See note 1
9.0 9.0 9.0
91/2 9.5 91/2
10.0 10.0 10.0
101/2 10.5 101/2
11.0 11.0 11.0
... ... ...
28.0 28.0 28.0
Notes:
  1. The form lengths shown are examples only. You can enter form lengths in one-sixth of an inch increments at the touch panel. For reference, see 81/3 and 82/3 above.

    The stacker control panel does not allow form lengths in one-sixth of an inch. The smallest increment allowed on the stacker control panel is one-third of an inch.

  2. The setting equals the forms length as measured from fold perforation to fold perforation. InfoPrint 4100 Models DO NOT support page sizes less than 76 mm (3 inches) in length.
  3. Form lengths as prefolded greater than 17.0 inches up to the maximum are permissible if a postprocessing device is installed and enabled.

    Form lengths greater than 28 inches can be used if the Signature Page feature (FC 4553) is installed.