Previous Page | Next Page Contents Glossary Index Appendix B. Work Sheets >

Snapshots Work Sheet

Use the work sheet on page Table 47 to record Snapshot settings. You have the option of saving all settings or of saving only form settings (Forms -> Form Settings). Make copies of the work sheets as necessary.

You may also find it helpful to make notes about loading techniques, adjusting print values, or other information that may be particular to certain Snapshots.

Table 47. Snapshots work sheet
Snapshot: Setting Value: Notes:
Forms -> Form Settings
  • Length
  • Width
  • Tractorless Side Verify Mark Location
  • Unit of Measure
  • Form Name
  • Host Setup ID
  • Form Barcode
  • Tractorless/Mark
  • Oversize Paper
  • Paper Weight
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
Printer Definition -> Print Quality
  • Contrast
  • Boldness
  • Preheat Temperature
  • Fuser Temperature
  • Oil Rate
  • Oil Belt Speed
  • Backup Idler Roll Usage
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
Printer Definition -> Printer ->Basic
  • Printer Mode
  • Printer Speed
  • POD Mode
  • Cutsheet Emulation
  • Printhead Resolution
  • IPDS Resolution
  • Front Sheet Sequence
  • Same Side Printing
  • Eject to Front Facing
  • Auto NPRO at EOF
  • Reprint Pages after Jams
  • Direct Attach
  • Language
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
Forms -> Print Registration -> Advanced
  • Simplex Side
  • Duplex Long-Edge Binding Front Side
  • Duplex Long-Edge Binding Back Side
  • Duplex Short-Edge Binding Front Side
  • Duplex Short-Edge Binding Back Side
  • _______________
  • _______________
  • _______________
  • _______________
  • _______________
Printer Definition -> Pre/Postprocessing->Postprocessing Options
  • Use Internal Stacker
  • Offsetter Enabled
  • BTS Enabled
  • Offset on Mark Forms
  • UP3I Enabled
  • _______________
  • _______________
  • _______________
  • _______________