Previous Page | Next Page Contents Glossary Index Preparing the Physical Environment > Space Requirements >

'H' Configuration for All Infoprint 4100 Models with the Tall Buffer/Flipper Unit (both printers facing the same direction)

Figure 38. 'H' configuration for all Infoprint 4100 Models with the Tall Buffer/Flipper Unit (both printers facing the same direction)
'H' configuration for all Infoprint 4100 Models with the Tall Buffer/Flipper Unit (both printers facing the same direction)
Notes:
  1. The Tall Buffer/Flipper Unit must be specified for Models HD3/4 in the 'H' configuration.
  2. The 'H' configuration requires about 42.25 square feet more floor space than earlier Infoprint 4100 models. The shaded areas indicate where changes were made to the 'H' configuration compared to earlier models. The distance between the printers and the turn bar and the Buffer/Flipper unit was increased by 610 mm (2 feet). The Tall Buffer/Blipper Unit was added to accommodate the additional paper length.
    Note:
    Figure 39 compares the old footprint for Infoprint 4100 Models HD3/4 with the footprint for Infoprint Models HD3/4 shipped after December 1, 2005.
  3. To allow for adequate cooling, a minimum paper length of 3657.6 mm (12 feet) is required between the forms exit area and the point in the postprocessing device where the forms are stacked, folded, or rewound.
  4. Service clearance of 1574 mm (62 in.) is required with or without the CCD Cart feature.
  5. Figures are not drawn to scale.
  6. For information about outlets and power cables, see Power Outlet and Cable Summary.
Important