Previous Page | Next Page Contents Glossary Index Preparing the Physical Environment > Physical Requirements >

Print Engine Power Cable and Receptacle

An AC power cable is supplied with all printers. This cable measures 427 cm (14 feet), except for printers installed in Chicago, Illinois, U.S.A., where the power cable measures 183 cm (6 feet).

U.S. and Canada

The printer uses cords with Hubbell plugs (IBM part number 53F1722, or IBM(R) part number 53F1723 for printers installed in Chicago; both include the cord and Hubbell plug type 460P9V05). Provide either of the following Hubbell connector or receptacle (or equivalent) for this plug:

460C9V05
Connector (inline)
460R9V0
Receptacle (mounts on a wall or rail)
Note:
These parts are available through Hubbell even though the part numbers shown may not be a standard item listed in their catalog. The Hubbell part numbers may have "HBL" prefixed to the part number shown above.

Figure 27 shows a Hubbell cord, plug, and receptacle.

Figure 27. Hubbell plug and receptacle Hubbell plug and receptacle

Positions for phase connectors R1, S2, T3, and ground (G) are shown. An angle back box may be used in conjunction with the receptacle.

All Other Countries

The power cable is supplied without a plug. Provide the appropriate plug and compatible receptacle.

Understand the electrical standards for your country, and use only an approved plug. Your IBM marketing representative has information on the voltage requirements in your country.

For more information about voltage requirements and for Hubbell part numbers, refer to the IBM General Information Manual: Installation Manual--Physical Planning, GC22-7064.