Removing forms

If forms are loaded in Printer 1, you must remove them from the printer before doing this procedure.

Do this procedure to remove the forms from the printer.

Procedure:

  1. Open the center front and center top covers of the printer.
  2. For fanfold forms, separate the forms at a perforation near the splicing table.
  3. Let the forms fall back into the input area but ensure that the end-of-forms sensor is not covered by the forms in the input area.
  4. Select Advance Paper (NPRO) on the touch panel, or press NPRO on the operator panel of either printer. The 078A END OF FORMS message appears on the touch panel.
  5. Select or press NPRO again. The forms move through the printers to the forms exit area or to a postprocessing device.