Using the Dual Toner Mark/Side Verify sensor in Duplex mode

Do this procedure to configure the printer to use the Dual Toner Mark/Side Verify sensor when printing on preprinted forms in tractorless mode. This sensor reads preprinted Top of Form registration marks on either side of the paper. This function will be useful when printing on preprinted forms, which may have registration marks printed on either the front or back side of the paper. The printer must be configured to look for marks on only one side of the form. When this sensor is used to read Top of Form registration marks, it must be installed in Printer 1.

The Dual Toner Mark/Side Verify sensor is also used when printing on the same side of a page in both printers. See Using the Dual Toner Mark/Side Verify sensor for same side printing for more information.

Note:
Before you can perform this procedure, the Dual Toner Mark/Side Verify Sensor feature (Feature Code 4570/9570) must be installed and enabled by your service personnel.

Procedure:

  1. Ensure that the printer is set to print in Duplex mode:
    1. Select Printer -> Basic to display the Printer - Basic panel.
    2. In the Printer Mode field, select Duplex.
    3. Select OK to save your changes.
  2. Select Forms -> Forms Settings to display the Forms Settings panel.
  3. In the Tractorless field, select Yes.
  4. Select Marks to display the Print Registration Marks window.
  5. Do either of the following for Printer 1 in the Preprinted Registration Marks area:
  6. Select Close to close the Print Registration Marks window.
  7. Select OK to save your changes.