About the splicing table

The Web Support Guides Release lever (2), Splice lever (3), moveable rear guide (5), moveable rear guide pins (1) and tape slot (4) are on the splicing table in the input area. Splicing forms together allows a job to continue with a new supply of the same type forms without reloading any forms.

Figure 13. Splicing table
Infoprint 4100 splicing table
Selecting This Control: Does This:
Moveable Rear Guide Pins (1) You can change the position of the guide pins to match the form size, as indicated by the form-width measurements marked on the splicing table.
Web Support Guides Release Lever (2) Releases the plate that covers the guide pins at the front of the splicing station.
Splice Lever (Vacuum Control) (3) Activates the splicing table vacuum. When the splice lever is down, vacuum is present, which holds splicing tape and forms on the splicing table. When the splice lever is up, no vacuum is present on the splicing table.
Tape Slot (4) Holds splicing tape in place during splicing. When the splice lever is down, the splicing table vacuum holds the splicing tape on the slot.
Moveable Rear Guide (5) Hold rear tractor holes of the forms during splicing.