Checking the toner collector

Procedure:

Do this procedure when you see the following message: 0787 CHECK TONER COLLECTOR.

Note:
  1. You must do this task immediately. You cannot delay doing this as you can for some "Out of Supplies" conditions.
  2. Do not switch power off to the printer during this procedure.
  1. From the rear of the printer, open the cover as shown.
    opening the covers
  2. Ensure that the toner collector is pushed firmly to the rear of the toner-collector table.
  3. If you had just replaced the toner collector bag when this message appeared, try removing and replacing the toner collector.
  4. If you have not replaced the toner collector bag, replace it now.
  5. Ensure that the toner-collector table is raised completely.
  6. Close the right rear cover of the printer.
  7. To resume processing, select Start on the printer operator panel or on the Main touch panel.
    caution 85
  8. If the CHECK TONER COLLECTOR message appears again, repeat the steps above. If that does not correct the problem, call your service representative.