Cleaning the rear service area

Procedure:

Do this procedure to clean the rear service area.

  1. Open the left rear and center rear covers of the printer.
  2. Vacuum any spilled toner from around and under the Toner Collector bottle.
  3. Use a soft cloth to clean the inside cover surfaces in the rear service area.
  4. Close all covers securely.
  5. Use a soft cloth moistened with water to clean the covers and panels.
    Important:

    Do not use commercial cleaners that might contain ammonia, solvents, or other volatile chemicals. The vapors from these cleaners can cause chemical reactions that reduce print quality.

  6. Power on the printer.
  7. Load forms into the printer, if necessary.

    This step is not required if you did not unload forms before you started this procedure.

  8. Enable the protocol, if necessary.