Cleaning and Servicing the printer

This section describes how to:

Clean the following areas of both printers before each shift:

Clean the following area at least once each week:

Recommendations About Cleaning the Printer

Procedure:

Do this procedure to clean the printer.

  1. Disable the protocol.
  2. Separate the forms at a perforation near the splicing table.
  3. Raise the static brush at the splicing table so that the forms fall back into the input area. Ensure that the end-of-forms sensor is not covered by forms in the input area.
  4. Advance the forms by doing one of the following:

    The 078A END OF FORMS message appears on the touch panel.

    Note:
    NPRO does not operate if the forms have not been aligned.
  5. Select Advance Paper (NPRO) or press NPRO again. In Duplex mode, the forms move through both Printer 1 and Printer 2 to a postprocessing device behind Printer 2. In Dual Simplex mode, the forms move through the printer to the stacker or to a postprocessing device behind the printer.

    If the forms have moved to a postprocessing device, switch off power to the printer. If the forms have moved to a printer stacker, unload the stacker and do the "Shutdown" procedure.

  6. Unload the stacker. Then perform the " Shutdown" procedure.
  7. Switch off power to the printer.
    Attention: Damage to the printer can occur if printer power is not turned off before you use the vacuum cleaner.
  8. Plug a toner-certified vacuum cleaner into an ac outlet near the printer.