Previous Page | Next Page Contents Glossary Index Working with forms > Loading forms--auto load (dual simplex mode) >

At the touchscreen or the printer operator panel

If forms are loaded in the printer, you must remove them:

  1. Open the center front and center top covers of the printer.
  2. Separate the forms at a perforation near the splicing table.
  3. Raise the static brush at the splicing table so that the forms fall back into the input area. Ensure that the end-of-forms sensor is not covered by forms in the input area.
  4. Select Advance Paper (NPRO) on the touchscreen, or press NPRO on the operator panel of either printer.

    An 078A ND OF FORMS message appears on the touchscreen.

  5. Select or press NPRO again.

    The forms move through the printers to the stacker or to a postprocessing device.

  6. Continue to At the printer forms input area.