Previous Page | Next Page Contents Glossary Index Operating the printer >

Adjusting the volume of the operator alert assembly

The operator alert assembly has three main parts:

To change the volume on the printer operator alert assembly, do the following:

  1. Locate the knob at the base of the operator alert assembly at the top of the control unit.
  2. To increase the volume, turn the knob clockwise.
  3. To decrease the volume, turn the knob counterclockwise.
  4. Test the alarm volume by raising and then lowering the splice vacuum lever on the splicing table.
  5. Repeat steps 2 through 4 until you have adjusted the volume to the desired level.