Setting up the printer for printing with MICR toner

The following procedure describes how to set required values when printing with MICR toner. These values must be set on the printer where the MICR toner is installed.

1. Select Printer Definition -> Print Quality to display the Print Quality panel.
2. Select the following values:
   • Contrast = 4 *
     Note:
     You may need to adjust this to obtain proper signal strength.
   • Boldness
     • For 240 and 300 DPI fonts = 50
     • For outline fonts (480 and 600 DPI) = 50
     • For CMC7 outline font = 60
   • Preheat Platen Temperature = 85
   • Fuser Temperature = 50 (Hot Roll) (This is the highest setting you can select.)
   • Oil Rate = 85
   • Oil Belt speed = 50
   • Backup Idler Roll usage = Enable
3. Select Printer Definition -> Printer -> Advanced -> Font Smoothing to display the Printer - Advanced panel.

   Set the following values:

   • Single-byte Font Smoothing = No
   • Double-byte Font Smoothing = No