Previous Page | Next Page Contents Glossary Index Taking care of problems > Forms jams >

Stacker pendulum forms jam

Intervention Error Code
Stacker Pendulum Forms Jam (Auto Load) 0192

To clear the jam message from the printer operator panel and the touchscreen, you must press the Auto Load - Stop on the printer control panel.

Automatic reprinting is not necessary for this type of jam because printing was not occurring when this jam was detected.

  1. Press Auto Load - Stop on the printer control panel.
  2. Visually check to see if a forms jam is actually present.

    If Yes, continue at step 3.

    If No, go to step 4.

  3. Clear forms from the Stacker and Pendulum area
  4. If the intervention message is still displayed, press Check Reset on the operator panel of the affected printer or select OK on the touchscreen.
  5. Check for and resolve or postpone any other error or intervention message that appears on the printer operator panel or touchscreen.
  6. For Dual Simplex Operations: If you found a forms jam, reload forms. See Loading forms--auto load (dual simplex mode) or Loading forms--semiautomatic load (dual simplex mode).
  7. For Duplex Operations: If you found a forms jam, and the jam was within Printer 1, you need to begin the Load Forms procedure again (see Loading forms--auto load (duplex mode)).
  8. For Duplex Operations: If necessary, enter the Align Forms procedure (see Forms are broken between the printers).
    1. Select Forms Feed once. This provides enough forms beyond Printer 1 to splice (on the floor between Printer 1 and Printer 2) the forms that just auto loaded on Printer 1 to the forms remaining in the forms path. Use the splicing procedures found in Splicing forms on the Infoprint 4000.
    2. Complete the Align Forms procedure.
    3. Do all the steps in Checking forms alignment for both Printer 1 and Printer 2.
  9. Select Start on the printer operator panel or on the Main touchscreen panel for the affected printer.
    CAUTION:
    <85>For printers with microcode levels, version 11.6.128 and higher, both printers and attached pre and postprocessing equipment can be started from the main panel of the printer console and the printer operator panels. Visually assure that no other personnel are working on the system before starting the system.
  10. See Suggestions for preventing jams if the error occurs frequently.