Previous Page | Next Page Contents Glossary Index Working with forms > Threading the Buffer/Flipper Unit (duplex) >

H-configuration

Figure 81 shows the short Buffer/Flipper Unit from the front. Use this illustration when threading forms through the Buffer/Flipper Unit.

As the form enters the flipper, its rear edge should run close to the collar. As the form leaves the 45° bar, the edge should line up with the tractors of Printer 2. The result is that the forms are buffered, inverted between Printer 1 and Printer 2, and also make a 90° turn.

Figure 81. H-configuration using a short buffer/flipper unit
H-configuration using a short buffer/flipper unit