Previous Page | Next Page Contents Glossary Index Working with forms > Threading the Buffer/Flipper Unit (duplex) >

Left angle configuration

Figure 79 shows the tall Buffer/Flipper Unit from the front. Figure 80 shows the short Buffer/Flipper Unit from the front. Use these illustrations when threading forms through the Buffer/Flipper Unit.

One of the stationary bars (D) was removed from its normal position and installed at the lower back of the Buffer/Flipper Unit with bar (E).

Use Figure 79 to thread the forms through the Buffer/Flipper Unit. Use the arrows as guides from Printer 1 at the middle of the figure (arrow (1)) to Printer 2 at the bottom of the figure (arrow (5)). The result is that the forms are inverted 180° between Printer 1 and Printer 2 and also make a 90° turn.

The guide collars on the indicated roller bars, denoted by letters (A) through (C), were adjusted properly when the system was initially installed. Adjustments by you are probably not necessary, even if you are threading a form through the system with a different width than you previously threaded.

Figure 79. Left angle configuration for the tall buffer/flipper unit
Left angle configuration for the tall buffer/flipper unit
Figure 80. Left angle configuration for the short buffer/flipper unit
Left angle configuration for the short buffer/flipper unit