Previous Page | Next Page Contents Glossary Index Operating the Printer > Enabling and Disabling Attachments >

Local Channel Enable/Disable

Note:
Do not use this procedure if the "Remote Channel Enable/Disable" feature is installed.

The enable/disable status of host attachments cannot be changed for an individual printer or for the complete two-printer system unless the printers are in the Not Ready state.

You may make the printers Not Ready at either the printer Display/Touch Screen window or the stacker control panel. You must use that same panel or window to make the printers Ready.

This is an image that illustrates the Enable/Disable Attachments procedure window.

Enabling a Host Attachment

  1. From the Options pull-down menu, SELECT the Enable/Disable Attachments procedure.
  2. From the list of currently installed attachments, SELECT the attachment you want to enable, then SELECT the Enable push-button.
  3. Make the printers Ready.

Disabling a Host Attachment

  1. From the Options pull-down menu, SELECT the Enable/Disable Attachments procedure.
  2. From the list of currently installed attachments, SELECT the attachment you want to disable, then SELECT the Disable push-button.
  3. If you want the printer active for attachments that are not disabled, choose one of the following methods: