Previous Page | Next Page Contents Glossary Index Introducing the Infoprint 3000 > Functional Areas >

Splicing Table

The splice lever and the moveable rear guide pins are on the splicing table in the input area. Splicing forms together allows a job to continue with a new supply of the same type forms.

This is an image that illustrates the splicing table.
Using This Control: Does This:
Splice Lever (Vacuum Control)

1

Activates the splicing table vacuum. When the splice lever is set to Splice, vacuum is present. The vacuum holds the splicing tape and forms on the splicing table. When the splice lever is set to Run, no vacuum is present on the splicing table.
Moveable Rear Guide Pins

2

Holds the rear tractor holes of forms during splicing. You can change the position of these guide pins to match the form size, as indicated by the form-width measurements marked on the splicing table.
Tape Slot

3

Holds the splicing tape in place during splicing. When the splice lever is set to Splice, the splicing table vacuum holds the splicing tape on the slot.