Previous Page | Next Page Contents Glossary Index Appendix C. Special Features >

Move Mark Forms

When you enable this feature, any job that prints with mark forms has a new mark forms pattern on the header and trailer pages. The new pattern is longer and is printed on the side of the page (1) rather than in the center.

This feature is enabled or disabled by the key operator.

This is an image that illustrates the new mark forms pattern when the "Move Mark Forms" feature is enabled.

To enable or disable this feature, do the following:

  1. From the Options pull-down menu, SELECT Special Features.
  2. SELECT the 8B3964 feature.
  3. SELECT either Enable or Disable.
  4. SELECT the Close push-button.
  5. A restart occurs automatically. Do not attempt any other task until the restart completes.