Previous Page | Next Page Contents Glossary Index

Appendix A. Valid Form Lengths in Inches

Table 32. Examples of Some Valid Form Lengths in Inches
If the Form Length is: Use this value at the Display/Touch Screen: Use this value at the Stacker Control Panel:
3.0 3.0 See note 2
3.5 See note 2
4.0 4.0 See note 2
4.5 See note 2
5.0 5.0 See note 2
5.5 See note 2
6.0 6.0 See note 2
6.5 See note 2
7.0 7.0 7.0
7.5
8.0 8.0 8.0
81/6See note 1 8.1 See note 1
81/3 8.3 81/3
8.5
82/3 8.6 82/3
85/6See note 1 8.8 See note 1
9.0 9.0 9.0
9.5
10.0 10.0 10.0
10½ 10.5 10½
11.0 11.0 11.0
11½ 11.5 11½
12.0 12.0 12.0
12½ 12.5 12½
13.0 13.0 13.0
13½ 13.5 13½
14.0 14.0 14.0
Notes:
  1. You can define form lengths in one-sixth of an inch increments at the Display/Touch Screen. For reference, see 81/3 and 82/3 above.

    The stacker control panel does not allow form lengths in one-sixth of an inch. The smallest increment allowed on the stacker control panel is one-third of an inch.

  2. Setting equals forms length as measured from fold perforation to fold perforation.
  3. Form lengths as prefolded greater than 14.0 inches are permissible if the stacker is disabled and a postprocessing device is installed and enabled.