Previous Page | Next Page Contents Glossary Index Configuring the System > Defining Forms >

Setting/Adjusting the Oil Rate

The Oil Rate selection in the Forms Characteristics box allows you to adjust the flow of oil to the oil belt. The number you enter is a relative number, not a measurement of amount. A default value is set during printer configuration. This default value is used if you enter 0 (zero) or leave the field blank.

This is an image that illustrates how to start setting the oil rate

To set or change the oil flow rate, do the following:

  1. SELECT the Oil Rate field. A keypad window appears.
    This is an image that illustrates how to enter a number between 1 and 100 for oil flow rate
  2. Enter a number between 1 and 100 where 1 is for the lowest flow rate and 100 is for the greatest flow rate.
    Note:
    The number you enter is not a measurement of amount.
  3. or
  4. To use the default rate value, enter 0 (zero) on the keypad. To determine the default value, look at Oil Rate in Printer Configuration.
  5. SELECT the OK push-button on the keypad.
  6. When you finish making all changes to forms, SELECT the OK push-button on the Define Forms window.