Previous Page | Next Page Contents Glossary Index Taking Care of Problems > Clearing the Forms Path >

Fuser and Stacker Areas

This is an image that illustrates how to open the top and front left cover and the stacker gate
  1. Open the top and front left cover and the stacker gate.
  2. Break the forms at a perforation near the pendulum.
  3. Unload forms from the stacker. See Unloading the Stacker.
  4. Close the stacker gate.
    This is an image that illustrates how to press and hold the puller lever down
  5. Press and hold the puller lever down.
  6. Grasping the forms near the fuser entry area, pull them up and out of the fuser. (This moves the forms in the opposite direction from their usual path.)
  7. If the forms will not pull up, or if some forms remain in the pendulum, do the following:
    1. Lower the stacker table.
    2. Open the stacker gate.
    3. Grasp both sides of the forms and pull down evenly.
    4. Close the stacker gate.
    5. Raise the stacker table.
     This is an image that illustrates how to open the oiler-belt gate
    This is an image that illustrates the caution of waiting 30 minutes
    This is an image that illustrates the caution about the oiler belt and fuser being hot
  8. If forms remain in the fuser, do the following:
    1. Open the oiler-belt gate.
    2. Lower the hot roll shield.
    3. Remove any forms you see.
    4. Raise the hot roll shield.
    5. Close the oiler-belt gate.
  9. Return to the appropriate jam message listed in Forms Jams.
This is an image that illustrates how to open the stacker gate