Previous Page | Next Page Contents Glossary Index Taking Care of Problems > Clearing the Forms Path >

Transfer Station Area

  1. Open the top left and front left center covers.
    Attention!

    Do not use the Forms Feed push-button on the printer Display/Touch Screen if forms are jammed in the transfer station.

  2. Break the forms at a perforation in the input area below the transfer station.
  3. Break the forms at a perforation between the tension arm area and the fuser entry area.
    This is an image that illustrates how to raise the transfer station away from the photoconductor drum
  4. Raise the transfer station away from the photoconductor drum.
    Attention!

    The photoconductor drum is easily damaged, and it is very expensive to replace.

    When the transfer station is open, the photoconductor drum is automatically covered to prevent damage to the drum.

    This is an image that illustrates the caution about wearing jewelry when working on the printer
    This is an image that illustrates how to open the lower transfer station tractor covers
  5. Open the lower transfer station tractor covers.
  6. Check for torn carrier strips, oversized carrier holes, and torn paper.
  7. Remove any torn forms, carrier strips, and paper chads from the lower tractor area.
  8. Close the lower tractor covers.
  9. Lower the transfer station and latch it securely into position.
    This is an image that illustrates how to lower the transfer station and latch it into position
  10. Open the upper transfer station tractor covers.
  11. Check for torn carrier strips, oversized carrier holes, and torn paper.
  12. Remove any torn forms, carrier strips, and paper chads from the transfer station area, the transfer corona, and the retractors.
  13. Close the upper tractor covers.
  14. Press the Forms Feed - Forward push-button to clear the forms from the fuser area.