Previous Page | Next Page Contents Glossary Index Working With Forms > Verifying Synchronized Duplex Printing >

Enabling Verification Checking

Note:
In printers with code version 9.608 or higher, the Side 2 Verify feature is enabled at the factory. You must have the CE disable the factory-set feature. However, once the factory-set feature has been disabled by the CE, you can enable and disable Side 2 Verify as needed.

Verification checking is valid only in duplex mode.

  1. SELECT the Configure pull-down menu on the Display/Touch Screen window.
  2. SELECT the Configure Pre/Postprocessors... procedure.
  3. SELECT the Side2Verify option.
  4. Change the configuration information:
    1. If necessary, set PORT to port number 3 where the control card is connected to the Mechanism Interface Card (MIC). (This would have been set by your service representative and would not normally be changed.)
    2. SET the Enabled field to Yes.
      Note:
      You cannot change the Printer, Characteristics, and Pre/Postprocessor Type fields.
  5. SELECT the OK push-button to exit the menu.

    The detailed status area on the Printer Status window on the Display/Touch Screen indicates "Side 2 Verify" when this feature is enabled.