Previous Page | Next Page Contents Glossary Index Working With Forms >

Checking the Forms Alignment

Do this task when you see a CHECK FORMS ALIGNMENT message or whenever you load, splice, or adjust forms.

This is an image that illustrates how to ensure that the forms perforation is aligned with the correct forms length.
  1. At the upper rear transfer station tractor cover plate, ensure that the forms perforation is aligned with the correct forms length.
  2. If the forms perforation is not aligned correctly, do the following:
    1. Use the Forms Feed key on the Printer Control Panel to adjust the position of the perforation.
  3. If you are using the on-board stacker, ensure that the Forms Set indicator on the Printer Control Panel is set to match the fold direction of the first fold perforation below the perforations on the forms guide.
  4. If you are doing this procedure as a step in a Printer Error or Intervention Required procedure, continue with the steps in that procedure.
  5. If you are doing this when you load, splice, or adjust forms, SELECT the Ready push-button on the Display/Touch Screen window for the affected printer to continue processing.